sw_release
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
sw_release [2018/12/05 19:10] – arzaman | sw_release [2019/03/01 11:48] – [SPC1000-base-wifi-v0.5-014.bin] arzaman | ||
---|---|---|---|
Line 111: | Line 111: | ||
+ | ==== SPC1000-biab-v1.3-010.bin==== | ||
+ | |||
+ | Date 19 jan 2019 | ||
+ | |||
+ | * Added Breefather integration components | ||
+ | * Added MQTT process start command | ||
+ | * Added MQTT pump on/off command | ||
+ | * Added pump cycle pause/ | ||
+ | * Added pump status in MQTT dynamic data | ||
+ | * Added possibility to skip step mash in BIAB recipe | ||
+ | * Fixed bug where mash and HLT heater outputs are enabled unconditionally upon resuming a paused process in automatic run mode | ||
+ | * Added PWM control of mash channel during boil phase via MQTT commands | ||
+ | * Added pump status icons | ||
+ | |||
+ | **NOTE** this SW release is mandatory for [[https:// | ||
+ | |||
+ | {{ : | ||
===== Smart Thermostat ===== | ===== Smart Thermostat ===== | ||
Line 235: | Line 252: | ||
date 03 Dec 2018 | date 03 Dec 2018 | ||
+ | * Added Brewfather integration components | ||
* Removed operation of PA13 pin as digital output, to fix current consumption issue causing a voltage drop that interferes with NTC probe measurements | * Removed operation of PA13 pin as digital output, to fix current consumption issue causing a voltage drop that interferes with NTC probe measurements | ||
* Fixed bug where software may freeze when probe configuration is changed from DS18B20 to NTC | * Fixed bug where software may freeze when probe configuration is changed from DS18B20 to NTC | ||
+ | |||
+ | **NOTE** this SW release is mandatory for [[https:// | ||
{{ :: | {{ :: |
sw_release.txt · Last modified: 2019/03/01 11:48 by arzaman